Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Marper

Pages: 1 ... 11 12 [13]
181
Installation issues / RESOLVED: Re: PXE MD Netowk
« on: December 24, 2007, 10:46:48 pm »
The eth switch I have has two ports that are specifically 10/100.  I had to move some cables around and when I changed the cable for the MD, BINGO - 1000 Mb.

Sometimes you have to read the manual

182
Installation issues / SBLive and ALSA Mixer No Sound
« on: December 24, 2007, 08:57:20 pm »
Hi all,

I've got a SB Live PCI Card that I cannot get any sound out of.   Here is what I have done:

1.  Used Alsamixer to unmute the IEC958
2.  Used KDE Mixer to ensure everything was setup properly (not sure if yellow is on or off)
3.  In sound section of LinuxMCE Launch Manager - does not show Audio Driver - on Audio Tab
4.  When I reload the router - sometimes, not always, I get SBLive Disabled (I have selected SBLive in the MD setup in the wizard.

Can someone tell me where I'm going wrong ?????


183
Installation issues / PXE MD Netowk
« on: December 24, 2007, 08:53:00 pm »
Hi all,

Finally got my Core and MD to boot well and work and so excited.  However, when I first set the system up, my MD indicated established connection on eth0 at 1000 Mb.  After a number of reboots and video config, it now says 100 Mbs. 

Is there a way to change that ?

MD Sys Specs:

ASUS P4P800 Mobo
2 Gb RAM
500Gb Hdd
Yukon eth0 Gb
SBLive Sound Card - no sound
MCE Remote
Nvidia XFX vidoe (using DVI ----  HDMI)

Thanks in advance, I'm now a true Linux Fan

Pages: 1 ... 11 12 [13]