is there a way to chnage the songs from the console? if i shh in from another pc?
Rule #1 - Be Patient - Rule #2 - Don't ask when, if you don't contribute - Rule #3 - You have coding skills - LinuxMCE's small brother is available: http://www.agocontrol.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
What do you have to capture the IR from your remote with? What are you using to send the commands to the devices from the MD? Juliet is correct about the process but the larger pieces need to be addressed first.
When the hardware is connected and enables at the learn command step you point your remote at the sensor (front of the USBUIRT if thats what your are using) preferable withing 12" and it should capture the command.
I hope this helps.
From the interface , main menu, advanced submenu, click on the "Infrared Codes" button.
You will see a list of devices that respond to IR codes. You have to select the device you want and click on advanced button (in the right side).
Then, in the right column you will see the list of available commands and the 'learn button'.
Click on "learn" for the command you want, and you will see the message: "Waiting for IR code". At that moment you have to point your remote at the IR receiver and press the corresponding command button on your remote.
You will see the message stating the command was learnt. Sometimes, it fails to learn it and you have to try again.
There is also another way to input IR commands, by copy-paste them in their specific format (if you find them listed anywhere like this). You can do that from the web admin page/ AV Equipment section, click on AV Properties for the device you want to control.
I have the same problem as Erik, fluffy and jester. My vid card is a nvida 6500.
Fluffy, could you tell me how you edited /etc/X11/xorg.pluto.conf? I am a bit of a linux newbie (though not a comptuer newb) so any help you might give would be appreciated.
I Get the same issue as Eirik above, my graphics card is a Nvidia 6200
Snippet from /var/log/pluto/19_LaunchOrbiter.sh.log
01 05/17/07 23:29:05.840 Thread -- GL.InitVideoMode FAILED Width: 640 Height: 480 Full Screen: 0 Composite: 1 <0xb6407b90>
After a bit more fiddling, if i edit /etc/X11/xorg.pluto.conf and comment out
The display then loads correctly :-)
i saw a similar problem and i solved it by renaming kdm.saved in /etc/init.d to kdm.