Messages

46

Installation issues / Re: Software RAID in 08.10 not detected.

« on: February 05, 2009, 09:20:18 am »

Still nothing...
So I did a umount and a e2fsck on the raid, and after a reboot the media started showing up

47

Installation issues / Re: Software RAID in 08.10 not detected.

« on: February 04, 2009, 10:56:31 pm »

Still nothing... I have rebooted at least 5 times, and the last time it has had 4 hours of nothing... I don't think it will happen automagically...

I'll try running

Code: [Select]

/usr/pluto/bin/UpdateMediaDaemon.sh now...

48

Developers / Re: My 0810 Alpha 2 experiences so far...

« on: February 04, 2009, 01:28:30 pm »

I also have camera showing up, even though I have no camera on the network... I think it's my Pioneer Receiver...

49

Installation issues / Re: Software RAID in 08.10 not detected.

« on: February 04, 2009, 10:50:54 am »

It has still not detected my media, and I can see the symlink in media sync, but it's not been detected as a folder yet...
I have not pressed resync or run UpdateMediaDaemon.sh yet, just to se if it kicks in by itself.
I have tried a new restart jus to see.
UpdateMedia is still running...

50

Installation issues / Re: Software RAID in 08.10 not detected.

« on: February 04, 2009, 08:41:01 am »

The checkforRaids.sh command was probably run on every boot by the Launch manager or something. Where is that now?

In 7.10 if I had a problem with the raid media, I just shutdown disconnected the raid and then deleted it from the webadmin. When I plugged it in again LMCE found it, and I set it to use the pluto structure in the webadmin and a new reboot. After a while all media was back.

51

Installation issues / Re: Software RAID in 08.10 not detected.

« on: February 04, 2009, 08:36:37 am »

After the reboot, the symlinks where created...
So I guess if I leave it for now and go to work, it's done when I return.

52

Installation issues / Re: Fiire remotes in 8.10

« on: February 04, 2009, 08:30:07 am »

I se no "MCR Remote Dongle device" there...
Just the following:
  Orbiter Embedded Phone
  Xine Player
  Photo Screen Saver
  MPlayer Player
  VDR

I could add it manually...

53

Installation issues / Re: Software RAID in 08.10 not detected.

« on: February 04, 2009, 08:22:42 am »

I will... I have not run your command yet to test...
And, yes, I have set the Pluto structure setting

54

Installation issues / Re: Software RAID in 08.10 not detected.

« on: February 04, 2009, 06:39:28 am »

It's running, but it's not finding my media on the Raid.

Code: [Select]

linuxmce@dcerouter:~$ /usr/pluto/bin/UpdateMediaDaemonControl.sh -status
Wed, 04 Feb 2009 06:38:10 +0100 UpdateMedia is running (PID - 8391)
linuxmce@dcerouter:~$


55

Developers / Re: Note to all hackers, we need help.

« on: February 03, 2009, 03:30:16 pm »

if you are going to do a clean install, do a clean install of alpha-latest, not alpha1

Just follow the instructions in the wiki for installing alpha1, but use the filename
new-installer-alpha-latest.tar.gz
in place of the old
new-installer-alpha1.tar.bz2

I edited the installer to use alpha-latest instead of alpha1...
Are there more changes in the new installer?

56

Installation issues / Fiire remotes in 8.10

« on: February 03, 2009, 01:24:11 pm »

My Fiire remote runs as a normal 2 button mouse in 8.10.
Is the software for the Fiire remotes not installed in 8.10?
Anyone know what to install?

57

Installation issues / Re: Software RAID in 08.10 not detected.

« on: February 03, 2009, 01:22:13 pm »

Well, Aplha 2 did not find my raid either...

But you are right, running your command adds the Raid to the database and it now shows up in the Webadmin.

58

Installation issues / Re: Software RAID in 08.10 not detected.

« on: February 03, 2009, 12:51:19 pm »

I'll try, I'm currently installing 8.10 Alpha2...

59

Installation issues / Re: Terratec C PCI HD DVB-C Card in PCI-X Slot using LinuxMCE 0710

« on: February 03, 2009, 12:48:45 pm »

The driver works, since you have compiled and installed it for 7.10. But the software (VDR or Mythtv) does not know about this driver, since it is using a new API called S2API. This API was released 1 month ago in the latest linux kernel. VDR and Mythtv supports Multiproto wich is the API that the Mantis driver uses. If you want to know more about why Multiproto never got integrated in the kernel you will have to google it.

The Raid I am using is SW raid from 7.10. And sadly it is not detected in 8.10. I can browse it in KDE....
But right now I'm installing a fresh 8.10 so it might work...

60

Developers / Re: Note to all hackers, we need help.

« on: February 03, 2009, 10:26:28 am »

http://wiki.linuxmce.org/index.php/LinuxMCE-0810_alpha1#Upgrading_pluto-storage-devices

That did nothing for me.... Trying a clean install