Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Digit

Pages: [1]
1
Users / Re: New PLCBUS driver
« on: December 22, 2011, 11:55:21 pm »
Hi all,

I'm new here and kind of 'invited' to say something about PLCBUS power usage, so here it goes  ;)
I have lots of PLCBUS appliance modules and my measurements show me the following numbers:

No load attached:
An appliance module uses an average of 0.3W while it's OFF.
When you change it to ON, this changes to 1.5W.

Load attached:
OFF stays the same, still 0.3W
ON: a bit harder to measure, but it looks like it's still below 2W.

So in normal operation you could say that a PLCBUS module uses 0.3W extra in OFF and 1.5W extra while ON.
I made a picture of the power monitor to prove this, but I'm not allowed to post links here, sorry about that.
Well, a link can be found in my guestbook at www dot hekkers dot net somewhere....

Hope this answers your questions,
Robert.

Pages: [1]