Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - jhammond

Pages: [1]
Installation issues / WinTV PVR-USB2 2900 series not detected PNP
« on: June 15, 2009, 10:08:29 am »
I've got 2 WinTV PVR-USB2 captures boxes and neither is detected and setup PNP. Searching the forums, I found this thread and was going to post in it, but it's a little older:

I don't see anything in Trac about it, but I'm sure a couple things fell through the cracks when the bug tracking system got changed.

Here is my DCERouter.log from when I plugged in the device:


I've done a fresh install of 0810alpha2 following the wiki and installed the pluto-zwave-lighting package, however neither my usb-uirt nor Intermatic HA-22 stick are recognized and used. Both work plug and play in 0710 (after replacing the ZWave driver) however I can't even add them manually in 0810. A thumb drive with a movie on it was detected and used automatically so HAL seems to be working. Surely someone else with a usbuirt or zwave stick has done a fresh install with the new alpha and either gotten these working or run into a similar problem?


Pages: [1]