Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - ladekribs

Pages: [1]
Users / Can I control a DLNA device (SONY TV) from Linuxmce?
« on: January 19, 2011, 01:56:58 pm »
I would like to power on/off a Sony TV via the network using DLNA commands, and maybe also select input,control volume etc.

Is it possible?
where can I find the command syntax?

BR Stefan

Users / Foscam FI8918W has anybody got it working?
« on: November 29, 2010, 12:02:49 pm »
I Ordered a Foscam FI8908W after reading that Barney had got it working, but the supplier where out of that type so I got one FI8918W instead, it is supposed to be better wider viewing angles and such,but it dies after five to ten minutes when I have it connected to my LinuxMCE LAN, so I connected it to a router with only one pc on the lan, and there it stays alive.

what can be killing the camera so that I have to power it off/on to get it working (disconnecting/reconnecting ethernet wire might help)?

any Ideas?

BR Stefan

Users / CISCO 7965 would it need much work to get it running as Orbiter?
« on: September 29, 2010, 09:30:29 am »

Hi all,

I have a Cisco 7965 what is needed to get it running as an Orbiter?

Or just as a phone?

TIA Stefan

Users / how to clean the device database
« on: October 10, 2009, 11:01:12 am »
Hi all,

I screwed up my device database, how can I empty it so I can make a new install without installing Kubuntu from start?

Best Regards Stefan

Installation issues / LMCE 0810 SqueezeBox Player / Sound Bridge
« on: August 11, 2009, 12:11:48 pm »
Hi all,

Should Player / Sound Bridge get registered?

they both stay at: Status **RUN_CONFIG** and Registered: No

but works both in Squeezcenter and controlled from Orbiter.


Users / USBUIRT transmit failed
« on: January 31, 2009, 05:58:49 pm »
Hi All,

USBUIRT transmit failed

I installed the (new and shiny) USBUIRT device and made it learn some LINUXMCE commands so I can run the orbiter with a remote. ok

then I applied Seths/Enoodles fix

opened the A/V properties in the A/V equipment wizard,

I went to the "Edit IR codes" page and enter some codes like "00 01 02 03 04 05 06" "update" and "test code" a message pops up saying:
The command was sent to device #131

but the /var/log/pluto/130_USB_UIRT_0038.log says:

UsbUirt transmit failed sending 00 01 02 03 04 05 06! <0xb6046b90>

and the LED on the USBUIRT stays dark

what am I doing wrong why canĀ“t I get it to transmit?

Pages: [1]