Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - cbynaker

Pages: [1]
Developers / Test build of 0704 from svn sources
« on: November 29, 2007, 02:01:12 pm »
I ran a 'svn update' just prior to running make on release 461 of the code. No compile attempts prior

This is on a machine < 12 hours old installed from CD distribution of linuxMCE 0704

charles@dcerouter:~/lmce$ make
I need to run sudo...
Retrieving updated package lists
Failed to fetch  404 Not Found
E: Some index files failed to download, they have been ignored, or old ones used instead.
Installing general development packages
.....................................................dpkg: libslang1-dev: dependency problems, but removing anyway as you request:
 libxine-dev depends on libslang2-dev | slang1-dev; however:
  Package libslang2-dev is not installed.
  Package slang1-dev is not installed.
  Package libslang1-dev which provides slang1-dev is to be removed.
Installing mysql stuff (includes hacks for 0704)
Installing libxine development packages (includes hacks for 0704)
Installing Linux headers for installed Linux release, needed for pluto-asterisk
Installing lirc-source for installed Linux release
ivtv-source (TODO still needed? -- dtk)
Installing KDE development libraries
Removing libdvdnav-dev to make room for libxine version
touch: cannot touch `build/state_dev_packages_installed_442': Permission denied
make: *** [build/state_dev_packages_installed_442] Error 1

I am not using chroot or anything as the instructions for the source do not require it.

md5sum lmce-440.tbz # should be 591fae306bf5877b0a953b8ae3a68935
tar xfj lmce-440.tbz
mv lmce-440 lmce
cd lmce
svn update

Installation issues / GC100 botched install
« on: October 24, 2007, 09:06:14 pm »
I have been trying to get a GC100 installed on linuxmce.
I think it is well established that the script is broken. I used the "Add GC100" button which failed.
I used the MAC address hack which resulted in the GC100 being added but the IR ports did not appear to be added and when adding A/V device the IR ports box is not offered.

I also saw residue from the install where the secondary address was still active on the ifconfig and the  Device_DeviceData table had data in it that looked like what the gc100 config script was using. I hard coded my eth0 to on initial install from CD.

Is there a way to remove all remnants of the gc100 install or a way to manually add anything missing or not configured during the incomplete installation of the gc100. I need the IR and then serial to plug in my Sharp DTV


Pages: [1]