1
Users / How to get the update
« on: October 06, 2007, 04:45:38 am »
How do i get the new update. so i can run the new schudeler. Also i am a noob when it comes to linux
THanks
Mike
THanks
Mike
News:
Rule #1 - Be Patient - Rule #2 - Don't ask when, if you don't contribute - Rule #3 - You have coding skills - LinuxMCE's small brother is available: http://www.agocontrol.com
LinuxMCE sponsor
open.home.automation
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
Users / Channel Line-up
« on: October 01, 2007, 03:25:12 pm »
What is everyone using to get channel line ups? I have finally got my PVR-500 running but i need to get the channel Line up. I registered with http://www.zap2it.com/ but liunx MCE cant log in
Thanks
Mike
Thanks
Mike
3
Installation issues / PVR500
« on: October 01, 2007, 01:35:56 am »
Ok
Does anyone have the steps to get the pvr-500 running? I have been searching and to no aval i can not get my pvr 500 working. Who has the pvr 500 running?
Mike
Does anyone have the steps to get the pvr-500 running? I have been searching and to no aval i can not get my pvr 500 working. Who has the pvr 500 running?
Mike
4
Installation issues / PVR 500
« on: September 23, 2007, 06:00:00 pm »
OK on the page of tested good hardware. The pvr 500 should work. The problem is i an know very very little about linux. I just did the install off the dvd. It find the pvr 500 i select the turner in the setup wizard and it asked what is hooked up to it. But i have no choices. On the page it ask you to Alt-Ctrl-2 then type
apt-get install ivtv-firmware
rmmod ivtv
modprobe ivtv
I dont understand were to type this in
Thanks
Mike
apt-get install ivtv-firmware
rmmod ivtv
modprobe ivtv
I dont understand were to type this in
Thanks
Mike
Pages: [1]