1
Users / [Q] GC100 operation
« on: June 11, 2007, 05:12:06 pm »
Hi again,
A second question. I have a GC100 installed. There are some problems making it work, though. Here's my setup.
LinuxMCE is currently on the 192.168.2 network, which is the only one in use at the moment. The 192.168.80 internal network is not connected to anything. The GC100 is 192.168.2.70. LinuxMCE is 192.168.2.109.
When I use a utility on a windows laptop, I can directly send commands through tcpip to the gc100, and it works. But how do I set this up in linuxmce? I tried to follow the instructions, but I guess I am forgetting a step or two.
i
Could someone please shed some light on this? I would be very happy if I could send $<"PC_*11\r"> to an Arcam receiver connected to the gc100.
Cheers,
Mark
A second question. I have a GC100 installed. There are some problems making it work, though. Here's my setup.
LinuxMCE is currently on the 192.168.2 network, which is the only one in use at the moment. The 192.168.80 internal network is not connected to anything. The GC100 is 192.168.2.70. LinuxMCE is 192.168.2.109.
When I use a utility on a windows laptop, I can directly send commands through tcpip to the gc100, and it works. But how do I set this up in linuxmce? I tried to follow the instructions, but I guess I am forgetting a step or two.
i
Could someone please shed some light on this? I would be very happy if I could send $<"PC_*11\r"> to an Arcam receiver connected to the gc100.
Cheers,
Mark