1
Installation issues / update problems/mistakes made(solved)
« on: March 09, 2017, 05:10:55 am »
In a nighly crazyness i acidently applied the LTS security updates on 1 MD.It told me Warning i should apply security updates to my hardware stack to get LTS support.But now this MD is somekind of broken. If i want to boot up it loads the vmlinuz but then it
stoping and telling me Could not find ramdisk image; XX/initrd.img
If i look into the tftp folder the symlinks are there for initrd.img. I tried to copy the symlinks from a folder of another MD then the broken MD boots up but its then updating itself again and rebooting and then again telling Could not find ramdisk image; XX/initrd.img
so i went into LinuxMCE admin to MD Section and rebuild the image. The rebuild MD boots up but its then updating itself again and rebooting and then again telling Could not find ramdisk image; XX/initrd.img
I even deleted the MD,setup a new with all new Device names. It boots up applying itself updates reboots and same again Could not find ramdisk image; XX/initrd.img.
Is there a way to get it back normal?Why even after delete and new setup it seems to apply the security updates?How can i stop that now?And just let it do the normal updates when i setup a new 1 or rebuild the image?I hope there is a way.
Thanks so far
stoping and telling me Could not find ramdisk image; XX/initrd.img
If i look into the tftp folder the symlinks are there for initrd.img. I tried to copy the symlinks from a folder of another MD then the broken MD boots up but its then updating itself again and rebooting and then again telling Could not find ramdisk image; XX/initrd.img
so i went into LinuxMCE admin to MD Section and rebuild the image. The rebuild MD boots up but its then updating itself again and rebooting and then again telling Could not find ramdisk image; XX/initrd.img
I even deleted the MD,setup a new with all new Device names. It boots up applying itself updates reboots and same again Could not find ramdisk image; XX/initrd.img.
Is there a way to get it back normal?Why even after delete and new setup it seems to apply the security updates?How can i stop that now?And just let it do the normal updates when i setup a new 1 or rebuild the image?I hope there is a way.
Thanks so far