Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - m_azza

Pages: [1]
Installation issues / Re: Nb9wmaxx+voip iinet+asterisk+freebpx setup
« on: August 23, 2012, 06:30:30 am »
Is the modem/router/ata/wifi all one IP address and MAC on the external network or are the components separated somehow?  You were able to take the AP away from the external network and let the core DHCP have it so you might be able to do the same with the address info of the ATA.

All i have done is disabled the dhcp server on the dsl router and statically assigned the router an ip address of and the core with a static ip address on etho and on the same nic create a sub interface of eth0:0 (the dhcp linuxmce dhcp server address . (All the core setting are done in linuxmce admin web screen).

In regards to the modem/router/ata/wifi its all on the same ip address and mac. I guess i will have to try adding a ip phone or orbitor on the internal network through web admin and try and make some calls if possible. At the moment i Just to test to see if voip is being routered to the internal network like the wifi is.

Installation issues / Re: Nb9wmaxx+voip iinet+asterisk+freebpx setup
« on: August 21, 2012, 11:57:34 pm »
I have the ata working fine on the external network without using asterisk or linuxmce but how do i get asterisk to work with the ata through the external network.  at the moment  i have the external dsl/router/modem/ata on a network and the core on with a single network card in the core. So the nic has been setup with the following


the dhcp server from the core is working fine and im currently using the wifi on the external router and its recieving address which is good (because i have turned off the dhcp server on the external router).

 is there a way to use the external ata on the internal network ? basically how i have used the external wifi on the internal netork.

Installation issues / Re: Nb9wmaxx+voip iinet+asterisk+freebpx setup
« on: August 21, 2012, 08:05:24 am »
Currently i have the dhcp turned off on the dsl router/modem and the wifi turned on and working through the core dhcp server . I was hoping to still use the origanal external modem/router as the ata device also. does anyone know if it possible?

Installation issues / Nb9wmaxx+voip iinet+asterisk+freebpx setup
« on: August 21, 2012, 05:25:27 am »
Hi i have currently setup linuxmce 810 and im quite happy with it . But im wanting to start using linuxmce and asterick to handle incoming and outbound calls . At the moment the dsl router is doing this but would like to intergrate this into linuxmce .  my setup is the following:

dsl netcomm nb9wmaxx which plugs into core. (Dhcp is running on core) I also have an analog phone plugged into phone 1 port .

how should i configure the dsl modem and configure asterisk?
or does anyone have any links on maybe explaninng what i need to do .

Pages: [1]