Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - Bricker07

Pages: [1]
Feature requests & roadmap / Interaction with other automation products.
« on: December 07, 2009, 01:48:29 pm »
As an telecom and automation guy I'm interested in LINUXMCE.
However I do have some questions.
As I am from Belgium when I use the

Apex system internationals easy+ automation system
the linux based controller can be interacted with command structures like
sending for instance:
211, Temp, 21,5

Where 211 is a bus CANbus address, Temp is the function and 21,5 the degrees to set.

Is it possible to build these kind of structures when using LINUXMCE instead of using Z-wave of simular products?
And if it is possible how can we do this?


When I uses the open system from
they send UDP port numbers to the controller to control the house.

Can this also be implemented in the LINUXMCE?
And how can this be achieved?

The layout for Iphones, PDA, any other devices does this include
software to be installed on the devices or is some kind of export screen from a server used?
Is this design software free for use?

Would you be so kind to answer these questions?

Thanks in advance.

Best regards

Dirk Put

Pages: [1]