Messages

1

Users / Re: Is anyone really using X10 successfully?

« on: October 22, 2007, 09:22:38 pm »

Have experienced the same issues.  Tried all your referenced resources.  Could not get X10 working reliably.  Punted and went back to Misterhouse.

2

Users / Re: Unable to add Child Device CM11A

« on: September 27, 2007, 05:13:34 am »

Finally figured out what I was missing.   Zaerc's instructions are nearly perfect.  I am completely dense, however.  Quoting from line 2 of his Setup:

Create Child Device->Pick Device template->CM11A

is missing one step:

Create Child Device->Pick Device template->CM11A->Pick Device Template

which finally gives the Device Data screen to complete installation.

However, I am experiencing the same probs as the related post "RF Signal Problems - Bug in Pluto" which doesn't seem to be resolved.  The CM11A works for a short time and then no longer functions.  It will lock up and overheat if not unplugged.  Works fine with Misterhouse.

If anyone knows a solution to this issue  please post.

Rob

3

Users / Re: Unable to add Child Device CM11A

« on: September 20, 2007, 05:39:34 am »

Tried both the nite_man and Zaerc methods of access.  No luck.

Did take a look at the sound card device already installed in the Core/Hybrid tree and can see the Advanced screen where the Device Data is added and a Save button is available.

This screen never shows up during the Add Child or Add Interface process.

What is broke?

4

Users / Re: Unable to add Child Device CM11A

« on: September 19, 2007, 05:54:43 pm »

After you pickup a desired device template you should specify some parameters (if it's needed) in the pop-up window and press button 'Save' there.

Took a look again this AM.  There is no popup window after specifying the device template.  The only available option after specifying device template is "Close".  I have never seen the pop-up window with the "Save" option.

5

Users / Unable to add Child Device CM11A

« on: September 19, 2007, 06:07:49 am »

First Install of MCE, DVD install, Version 2.0.0.44.0708032200(?)

Trying to add CM11A

LinuxMCE Admin Page > Device Tree > The Core/Hybrid > Create Child Device > Pick Device Template > Category(81) Template(48) > Close ...

No device is ever added to the tree.  Should there be a Save button in addition to the Close?

What am I missing?

Rob

6

Users / Re: Status of the LinuxMCE DVD's

« on: September 10, 2007, 05:19:34 pm »

I'd be happy to chip in to help lower the cost of the first learning experience.  Your efforts are appreciated.

Rob