I am trying to use a laptop with network boot to act as a diskless MD.
I have followed the steps on http://wiki.linuxmce.com/index.php/Automatic_diskless_boot_of_media_directors
"In LinuxMCE Admin go to Wizard, Devices, Media Directors. Add the media director if this is a new one, and set the mac address. The mac address should be a series of six 2 character sequences separated by colons, like this: 1A:00:F2:21:23:9F"
However I go there and I see my core as a device then I go to add new at the bottom, I update the information (no where for a MAC address) then the only button I see is a close button and the information that I have just created is no where to be found.
I clicked setup diskless media directors and reloaded the router and the MD will not boot.
I can update with screenshots if needed because i am sure my descriptions are not the best.
Any suggestions or advice would be appreciated.