Messages

1

Installation issues / Linuxmce RC2 and subtitles

« on: May 22, 2008, 02:55:03 pm »

Hi!
I have just installed Linuxmce RC 2 core and I have 1 media director in addition to the core.
Most things works great, but........
I have noticed that the subtitles from my DVD's does not work, even though I have tryed to choose subtitle from the DVD menu in the Linuxmce UI.
Since I am norwegian, most of my DVD's have subtitles, and it is very frustrating to not have any availeble.

Could someone please point me in the right direction of how to configure this for my system?

Thanx in advance

2

Installation issues / Re: Configure mythtv frontend on MD

« on: April 30, 2008, 11:31:34 pm »

 
Thank you very much for you help and advice.

I will reinstall my dedicated Core to a Core/Hybrid since I am veeeery far from a guru.
Hopefully this will solve my problem.

3

Installation issues / Re: Configure mythtv frontend on MD

« on: April 30, 2008, 10:47:48 pm »

Thank you very much for your comments and suggestions.
But unfortunately, I am not any closer.

On my dedicated core, I have no Mediastation GUI........
During installation I never had any Housesetup wizard, only AWVisard configuration.
I did however get a housesetup wizard on my MD......
Is their something very wrong on my core?

Or should I install my Core as a Core/Hybrid since their is a PVR 500 in it?

4

Installation issues / Re: Configure mythtv frontend on MD

« on: April 30, 2008, 12:27:58 am »

Thank you for you reply!

Does this mean that I will need to download and install the mythtv packages on the core.
I can not see any trace of it installed on the core now.

I thought all these pacakges was bundled in to Linuxmce

5

Installation issues / Configure mythtv frontend on MD

« on: April 29, 2008, 11:54:55 pm »

Hi!
I am having a problem that I hope someone could give me a couple of pointers on.
I am trying to get mythtv to work on my system.

I have installed a dedicated core with 7.10 RC 1.
I have placed my PVR 500 in the core, and as far as I can see it works.
I tested it with cat /dev/video0 > /tmp/test.mpg, and a file with static was created. I have no channels scanned so far.

I have a diskless MD,  with UI2, that seams to work great.
When I am trying to run MythTV setup from computing on the MD, everything looks fine in the general section.
MD IP is set to 192.168.80.2 and the Master IP is set to 192.168.80.1

My problem
Under Capture Device->New Capture Device, it seams like the MD has no contact with my PVR.
Probed info shows ->Failed to open

If I try to run TV from the Linux MCE menu, I get the error message -could not connect to master backend server-

When I boot the MD I see a service called mythtvbackend service started.
Is this correct, I thought the backend was suppose to run on the core.
When I try to run: http://coreip/mythweb, I get the following error message:
Unable to connect to the master backend at 192.168.80.1:6543. Is it running?

By the way I have also configured my MD in plutoAdmin with a PVR 500 tuner card.

Could someone please give me a hint, of how to configure MythTV.

Regards
gfk