LinuxMCE Forums

General => Installation issues => Topic started by: jfreegard on November 17, 2009, 12:13:58 am

Title: Honeywell Galaxy Ethernet Module??????
Post by: jfreegard on November 17, 2009, 12:13:58 am

Hi All,

I've been hunting and hunting here in the UK for a supplier of the Vista series of alarm systems and the VistaICm but I've not been able to find them so far (still hunting though).
In the mean time does anyone know if LinuxMCE supports the Honeywell Galaxy Ethernet Module as the Galaxy series is readily available here.  If not any suggestions for an alarm system where I can use the PIR's with LinuxMCE to turn lights etc on would be greatly received.

Thanks

Title: Re: Honeywell Galaxy Ethernet Module??????
Post by: totallymaxed on November 17, 2009, 01:31:25 pm

Quote from: jfreegard on November 17, 2009, 12:13:58 am

Hi All,

I've been hunting and hunting here in the UK for a supplier of the Vista series of alarm systems and the VistaICm but I've not been able to find them so far (still hunting though).
In the mean time does anyone know if LinuxMCE supports the Honeywell Galaxy Ethernet Module as the Galaxy series is readily available here.  If not any suggestions for an alarm system where I can use the PIR's with LinuxMCE to turn lights etc on would be greatly received.

Thanks

The Honeywell Galaxy Ethernet module is not supported currently...and as far as I know may never be as this module seems to be limited by the firmware in the panel.

All the best

Andrew

Title: Re: Honeywell Galaxy Ethernet Module??????
Post by: los93sol on November 19, 2009, 03:41:35 pm

Try contacting In2Networks, they are the manufacturer of the device and may be able to work something out with you.  http://www.in2networks.com/contact.html