LinuxMCE Forums
Archive => Archive => Pluto Main Installation & IR codes => Topic started by: archived on September 08, 2006, 07:12:05 pm
-
I installed a logitech quickcam on a MD to see if they work as the documentation claims and alas it did not. Now I cannot remove the camera entry on any of the orbiters , even though I have removed it from the admin webpage and regenerated and rebooted and reloaded still it remains.
Any one have any ideas ?
Regards
Dean
-
Be sure that you did full regeneration not just a quick.
-
Thanks for the reply
I have done this more than once , to no avail.
I have since tried to connect the logitech webcam to my core , are you aware of any extra actions i need to take to get it to work. In the admin website under device status the camera status is now run_config. What does this mean.
Regards
Dean
-
I have a webcam in my installation. I followed by this guide (http://plutohome.com/wiki/index.php/Monitor_surveillance_cameras) to setup it. Also, remember to install and load appropriate driver for your webcam. YOu can use a command dmesg to check if everything fine with your webcam.