LinuxMCE Forums
Archive => Archive => Pluto Main Installation & IR codes => Topic started by: archived on June 01, 2006, 09:39:42 pm
-
I have a new MD which uses a VIA Rhine II network adapter. I have created a new MD in the web admin, set it with the VIA's MAC address in the format 00:00:00:00:00:00 and then built the diskless media directors, but the MD will not boot from PXE.
Is this network card a known problem card perhaps, or maybe I have forgotten do perform some vital step?
TIA,
Marcus
-
the DHCP server must be turned ON. If you remember, in the initiall install there was a step to start DHCP server.
If you start the DHCP server, should be ok.
-
DHCP is running. I swapped the card for a 3Com 905 and the MD booted straight away.
So there would appear to be issues with the Rhine adapters.
Marcus