LinuxMCE Forums

General => Installation issues => Topic started by: LmceCape on March 20, 2009, 04:22:20 pm

Title: GE Interlogix Interface
Post by: LmceCape on March 20, 2009, 04:22:20 pm
I hope somebody can help, I have been trying to get a GE Interlogix Interface working for about 3 weeks now and just can't win.

I am getting the following in "/var/log/pluto/LaunchManager.log"
"Starting device 63 GE Interlogix <0xb68388d0>
Not starting device 63 GE Interlogix -  binary is not found, probably it is in the middle of installation <0xb68388d0>"

It is a NX6 with a NX584 Home automation board setup the same as the "Caddx NX-8E" wiki but attached to the serial port on the core I have added the Com port, Flow Control and Baud Rate to the GE Interlogix template, but it never sends any data down the serial port.

I know everybody is very busy with 810 now, but if someone can point me in the right direction I would really appreciate it.

Thanks

Title: Re: GE Interlogix Interface
Post by: tschak909 on March 20, 2009, 09:06:54 pm
It looks like that device template does not exist anymore, and would need to have one created. You can contract me to do so.

-Thom
Title: Re: GE Interlogix Interface
Post by: LmceCape on March 22, 2009, 01:54:37 pm
Thanks for the quick response, how would I go about contracting you to do that???