LinuxMCE Forums
General => Installation issues => Topic started by: los93sol on January 16, 2009, 05:30:42 pm
-
Alright so I was finally kind of successful getting a device to work with LMCE, my camera works, but it drops out and loses the connection after about 2 minutes of viewing. Is there some explanation for why this is happening? I can view it a long a I want going directly to its web interface but for some reason LMCE says "Connection lost to camera".
I set the camera up by adding a motion wrapper to my hybrid then adding a generic analog camera to the motion wrapper. Please any advice would be greatly appreciated, I've checked everything I can think of so I'm hoping it is some silly setting I've missed. :)
-
RESOLVED: I had to set the camera's resolution to 640x480, the default setting was causing the camera to lock up constantly.
I also wrote up a Wiki page on setting the up the DCS-920 located here:http://wiki.linuxmce.org/index.php/D-Link_DCS-920 (http://wiki.linuxmce.org/index.php/D-Link_DCS-920)
Now back to this pesky alarm panel...
-
I've been trying to get a DCS-20 setup and configured. I've created the Motion Wrapper and the Generic Camera, however I get no picture at all. I've tried to go to your wiki writeup but it's not displayed. Any help you can provide would be greatly appreciated.
-
Disregard my last post, you are the bomb. It works thanks a million.