LinuxMCE Forums
General => Users => Topic started by: indulis on September 13, 2008, 08:57:40 pm
-
Hi,
Was looking to get a 7970G or 7971G. The only difference with the 7971G seems to be a faster network and higher resolution display according to the marketing blurb. Would it still work with LinuxMCE? If not, how could it be makde to work- big or small job?
7970G
http://www.cisco.com/en/US/products/hw/phones/ps379/ps5440/index.html
7971G
http://www.cisco.com/en/US/products/ps5946/index.html
Thanks!
Indulis
-
Hi,
I'm not sure if there is any difference in resolution. I've asked guy selling them on Ebay and he said the only difference is gigabit ethernet...
HTH,
regards.
Bulek.
-
they have the same firmware and should behave identical.
best regards,
Hari
-
OK found a table which summaries the differences- seems it is just Gbit ethernet on the 7971G and 10/100 ethernet on the 7970G.
So will probably buy a 7970G or two.
http://www.cisco.com/en/US/prod/collateral/voicesw/ps6788/phones/ps379/ps8538/prod_qas0900aecd80699b31.html
-
OK found a table which summaries the differences- seems it is just Gbit ethernet on the 7971G and 10/100 ethernet on the 7970G.
So will probably buy a 7970G or two.
http://www.cisco.com/en/US/prod/collateral/voicesw/ps6788/phones/ps379/ps8538/prod_qas0900aecd80699b31.html
If I remember properly, the 7971 can also forward your network cable, so it's got two gigabit ethernet ports.
I have 10/100 forwarding also on 7970...
Regards,
Bulek.
-
Hi,
I'm not sure if there is any difference in resolution. I've asked guy selling them on Ebay and he said the only difference is gigabit ethernet...
HTH,
regards.
Bulek.
7970g is Cisco inline power and 802.3af compliant
7971g is only 802.3af compliant NOT Cisco inline power compliant
7970g is 10/100 Mbps
7971g is 10/100/1000 Mbps
7970g won't get full brightness if powered over ethernet
7971g will get full brightness if powered over ethernet (I think !!???)