LinuxMCE Forums
General => Users => Topic started by: Crash on June 11, 2008, 05:59:08 pm
-
I've got an issue, and I'm fairly lost on what to do.
I'm using an ATI 2400xt video card, and after first install I followed the instructions in the wiki on how to update the ATI graphics drivers. After that, I rebooted the router, ran the AV wizard again, bumped to UI2 from 1, and now after mce starts, it drops me back to the dcerouter logon after just a few seconds. I have "/etc/init.d/kdm start" and it works, but again, only for a few seconds before dropping me back to the dcerouter logon.
Anyone know what's going on?
Thanks in advance,
-crash
-
Sounds like your display drivers aren't configured properly. You probably need to edit the xorg.conf file.
-
Well, I followed the directions and set the device from 'vesa' to 'fgrlx', is there anything else you think I'd need to change?
-
Well, I followed the directions and set the device from 'vesa' to 'fgrlx', is there anything else you think I'd need to change?
Yes I do, unless your satisfied with the status quo of course. And before you ask, I don't have one of those cards myself, so I don't know what to exactly change either. Try reading the rest of the page as well since it has some more general pointers on setting up a basic config file manually.
-
Ok, I'll keep playing and post my results.
Thanks,
-crash