LinuxMCE Forums
General => Users => Topic started by: Boz on May 12, 2008, 09:00:45 am
-
Hello,
Apologies for the basic question - I've been trying to configure my new core/hybrid to work with the remote which came bundled with my TV tuner card (Leadtek Winfast DTV2000H). I have the remote working fine with a basic MythTV install - but for LinuxMCE I'm completely stumped. The user guide talks about selecting the device template from the Devices -> Media Director view on the web admin. However, when I do this the remote still does not work. Further, when I try to configure my own device using the configuration file I used in my Myth install it still does not work.
Can someone please post some clear step-by-step instructions on how to configure an infrared remote? I've seen quite a few questions of this type in the forums so perhaps this would be of interest to a number of people.
Thank-you very much for your help!
Boz. :D
-
If you can get it working with a basic MythTV then you should be able to get it working with linuxMCE...
Make sure you are selecting the correct driver. I think that it will be "dev/input" for these.
If you check the log for LIRC_DCE device (in /var/log/pluto) then you should see an entry for each key press. If this is working but it is not doing something in linuxMCE then it may be a mapping issue for that device template. The mapping can be changed but I find it easier to just change the configuration for the remote so that it sends already mapped events. I think there is a wiki page with the know events on it (from memory).
Hope that helps a bit
Darren