LinuxMCE Forums

General => Installation issues => Topic started by: nite_man on October 02, 2007, 06:39:43 pm

Title: Reconfiguration network interfaces
Post by: nite_man on October 02, 2007, 06:39:43 pm

Hi,

I installed LinuxMCE with one network card. Now I'm going to add another one Ethernet interface. Is there some easy way to reset a current network configuration and re-configure it?

Thanks in advance.

Title: Re: Reconfiguration network interfaces
Post by: Zaerc on October 02, 2007, 09:26:17 pm

You need to make a couple of changes in different places.  There is a thread on this forum about it, searching for eth0:0 should find it.

Title: Re: Reconfiguration network interfaces
Post by: nite_man on October 03, 2007, 09:45:19 am

Quote from: Zaerc on October 02, 2007, 09:26:17 pm

You need to make a couple of changes in different places.  There is a thread on this forum about it, searching for eth0:0 should find it.

Thanks, I found solution - http://forum.linuxmce.org/index.php?topic=243.msg1022#msg1022 (http://forum.linuxmce.org/index.php?topic=243.msg1022#msg1022). It works!