LinuxMCE Forums
General => Installation issues => Topic started by: b-ran on October 01, 2007, 06:47:15 pm
-
I have a fresh install of MCE. I am using a Hybrid Core and and it is working. I wanted to add another MD when I did it I messed up the video and couldn't get the MD to work. So I went into the admin site and deleted the malfunctioning MD. Now I can't get any new MD's to start I can only use the Hybrid MD.
I get a TFTP file not found error when I try to PXE the same computer or another.
Do I needed to rebuild the TFTP files?
-
Sounds like some of the files from the old netboot weren't cleaned up properly while others were.
Check under /tftpboot/, there should be a subdirectory called pxelinux.cfg containing files named after the mac-adresses of the diskless MDs, I suspect that's where the problem lies. If you find them you could try moving the appropriate one out of the way by moving or renaming it. They are created automaticly when a new MD boots the first time.
-
On the bottom of the Media Director admin page, there is a button to 'Setup Diskless'. Try running that again and ensure that it completes successfully (could take a little while)
-
Try what darrenmason said first, which is easier anyway.
-
Thank you both for the help so far!!
I tried to setup diskless MD's and the admin site runs through it's configs but I sill fail to find files when tftp tries to run.
I also renamed the File in pxelinux.cfg and came to the same result.
In /tftpboot/ I also saw that I had two folders each with two items. They were /tftpboot/42 and /tftpboot/54. 42 and 54 are the numbers that were assigned to MD's in the past but they didn't work. I renamed then as well and saw no change.
I am using this PC normally but MCE finds it and asks me to set it up as a file server. Could the MAC address be recognized else where in MCE that would cause it to get a 192.168.80.248 IP instead of the 192.168.80.2 IP that I got when it booted with bad graphics config?
Again thanks for the Help!!
-
Thank you both for the help so far!!
I tried to setup diskless MD's and the admin site runs through it's configs but I sill fail to find files when tftp tries to run.
I also renamed the File in pxelinux.cfg and came to the same result.
In /tftpboot/ I also saw that I had two folders each with two items. They were /tftpboot/42 and /tftpboot/54. 42 and 54 are the numbers that were assigned to MD's in the past but they didn't work. I renamed then as well and saw no change.
I am using this PC normally but MCE finds it and asks me to set it up as a file server. Could the MAC address be recognized else where in MCE that would cause it to get a 192.168.80.248 IP instead of the 192.168.80.2 IP that I got when it booted with bad graphics config?
Again thanks for the Help!!
Try looking for the Mac address of your machine that will not pxe boot in Web Admin -> Advanced -> Configuration -> Unknown Devices
If you see a line with the 80.248 address then click the 'Unlock' button at the far right hand end of the line. Then try pxe booting the MD again and see if it announces itself properly this time.
-
That didn't work either...
I think that I am going to go with a fresh install. I need to change out my NIC as well. I haven't put much on the system so I am not losing anything but time.
Thanks everyone for there help. I didn't even know where to start.