LinuxMCE Forums
General => Developers => Topic started by: PeteK on September 23, 2007, 09:00:51 am
-
Hi--
I sent this question to the Pluto ZWave developer because it's a Z-wave question, but it might be generic enough that someone else here can answer:
Thank you for your help with this. I've been moving forward with
creating the Insteon interface. One issue that I am unclear about is
the mechanism for a lighting device (i.e a #38 Dimmable Switch) to
create, say a Zwave job, when it receives a message from DCERouter.
For example, on the lights page of the control html page, It has 'ON'
'OFF' and '50%'. If i understand correctly, these send a DCE Message
to the light device. How does the light device then trigger the
creation of a Zwave Job?
Thank you for your help
-
Hi--
I sent this question to the Pluto ZWave developer because it's a Z-wave question, but it might be generic enough that someone else here can answer:
Thank you for your help with this. I've been moving forward with
creating the Insteon interface. One issue that I am unclear about is
the mechanism for a lighting device (i.e a #38 Dimmable Switch) to
create, say a Zwave job, when it receives a message from DCERouter.
For example, on the lights page of the control html page, It has 'ON'
'OFF' and '50%'. If i understand correctly, these send a DCE Message
to the light device. How does the light device then trigger the
creation of a Zwave Job?
Thank you for your help
Not sure how this is implemented in Zwave wrapper, but do know how it goes :
- light device is usually child device of parent that is usually driver for some automation system. But all these child devices don't have that tick "implements DCE" , that means that all messages for child devices will be actually send to its parent and then driver activates proper job - so actually message never comes to child device....
HTH,
regards,
Rob.
-
Thanks for the info! It wasn't clear from the code how this happened.