LinuxMCE Forums

General => Users => Topic started by: Cynical on May 18, 2007, 04:38:14 am

Title: Hardware Newbie -- Choices!
Post by: Cynical on May 18, 2007, 04:38:14 am

Ok -- so I am a hardware newbie and I am wondering how to set things up. Software i can configure pretty easy, but it's the hardware that I am having trouble deciding on. So i thought i would reach out -_-


   Here is my plan:

I allready have a rack in the basement with a NAS. I want to put the core here. And have Media Directors at each TV. I have already run cat5e to each room that needs it (those with TV's camera's ect).

I have direct TV HD enabled. (dolby h20) as the main receiver.

Here is my question. From a hardware point of view, can i have the sat. receiver down stairs pluged into the core and have the core serve the channels to each TV, and record off of that feed? Or do i have to have an HD receiver at each TV and then media directors each with a TV card that can record HD?

Also -- how does linuxMCE physically interface with AC systems and lighting systems? I haven't had any luck looking this up, im going to home depot and lowes later on this week and plan on asking them as well. Just any ideas on what i should do/buy here.

Thanks in advance for any advise : )

Title: Re: Hardware Newbie -- Choices!
Post by: sharlee_angelo on May 18, 2007, 11:39:15 am

if your receiver can be connected to the computer, you could use only one receiver. for lighting, you have to have a zwave device or cm11.