LinuxMCE Forums

General => Installation issues => Topic started by: pigdog on December 20, 2015, 04:44:32 pm

Title: LMCE-1404 20151215194431754-i386 snapshot
Post by: pigdog on December 20, 2015, 04:44:32 pm

Hi,

No issues during initial install - AVWizard and Sarah OK.

NAS detected but had to Resynch media.

Going to run TBZ and create MD.

Cheers.

Title: Re: LMCE-1404 20151215194431754-i386 snapshot
Post by: pigdog on December 20, 2015, 09:26:12 pm

OK,

TBZ took like 3 hours start to finish but have a MD.

Had to adjust analog stereo on Core using alsamixer - volume low.  MD with HDMI audio OK.

ssh to moon OK.

I don't use Myth.

Cheers

Title: Re: LMCE-1404 20151215194431754-i386 snapshot
Post by: phenigma on December 20, 2015, 11:10:59 pm

Quote from: pigdog on December 20, 2015, 04:44:32 pm

NAS detected but had to Resynch media.

Do you mean to say that UpdateMedia was not running at all?

J.

Title: Re: LMCE-1404 20151215194431754-i386 snapshot
Post by: pigdog on December 21, 2015, 01:29:56 pm

Hi,

I let it sit for half an hour and UpdateMedia didn't scan the contents.

However, the NAS had some kind of communication happening because it did not go into "sleep" mode.

(One particular LED would have timed out and turned off due to lack of activity on the comm link).


Cheers

Title: Re: LMCE-1404 20151215194431754-i386 snapshot
Post by: pigdog on December 21, 2015, 03:02:23 pm

Hi,

Presently doing the 64 bit install and during adding the HDD volumes on the NAS I caught the following messages flying by...

I believe it said "Failed to get LinuxMCE media identifier" , it was pretty quick.

Cheers.

Title: Re: LMCE-1404 20151215194431754-i386 snapshot
Post by: pigdog on December 21, 2015, 05:26:33 pm

Hi,

I'll check this load for update/upgrade because for amd64 variant updatemedia ran after upgrade applied.

Cheers.

Title: Re: LMCE-1404 20151215194431754-i386 snapshot
Post by: phenigma on December 22, 2015, 07:23:59 pm

All the dvds I've tested are running updatemedia on installation, the checkmark in webadmin is not sticking on any of them though.

FYI, it takes about 10hrs for some media to show up when scanning my NAS, I leave it overnight and everything is available in the morning.  So leave things overnight in the scan and it should be there in the morning.  This is usually only necessary on initial installs with a fresh database.

J.