LinuxMCE Forums
General => Installation issues => Topic started by: davegravy on September 08, 2014, 06:48:31 am
-
I added this device using PnP via orbiter. After detection and device creation it appears LMCE is completely unable to communicate with the controller. See log:
http://paste.ubuntu.com/8287313/ (http://paste.ubuntu.com/8287313/)
This same stick in the same hardware config works on 1004.
Phenigma mentioned in IRC seeing similar issues but got things working by doing a few things including resetting his Z-stick. I will if there's no other choice, but I have all my node info from 1004 on the device and I'd rather not break that.
Not sure if it's abnormal but I've deleted and re-added the device several times, with the dongle in the same physical usb port, and the /dev/ttyUSB2 seems to change (it's shown up as USB0 an USB1 in the past)
Any ideas?
-
Some combination of unplugging/replugging and rebooting fixed it. Wish I could provide more info!
-
My guess is a combination of a lock-up of the stick (some Aeon sticks will lock up and have to be un/replugged to resume normal operation), and mismatch between the port configured and the actual port. (Re-plugging a device might assign it a new port as well).
br,
sambuca