LinuxMCE Forums
General => Installation issues => Topic started by: pigdog on July 28, 2014, 05:46:13 pm
-
Hi,
On initial install no network configuration messages but did get some systemd-udevd messages until hal loaded.
A/V Wizard - no problems.
Setup Wizard ran with no Sarah A/V.
ifconfig was good, using Nvidia drivers, no Flickr photos.
Confirm Dependencies log showed the usual suspects.
Did update/upgrade with just
report chown: cannot access //var/www/mythweb/data 0 and dpkg:error processing package pluto-mthtv-plugin ( -- confure):
Edited lanman client change in smb.conf and restarted service
Powered up NAS. NAS discovered. Volumes detected. UpdateMedia discovering content.
I built a MD profile, was discovered by the router but failed Diskless_Setup.sh.
Message after fail [ 33.396623] random: nonblocking pool is initialized
Cheers.
-
The lanman setting should have been already in... could you verify, please.
-
Hi,
lanman had to be edited into /etc/samba/smb.conf
Cheers
-
Could you check if the smb template files under /usr/pluto/ contain the changes
-
Let me reply to myself. Looking through all scripts et al, I realized the smb.conf.tmpl is another of those NOT used goodies, Plutu came up with :(
I'll amend Network_Setup.sh to add the lanman settings.
-
I need to correct myself, and voice an apology to the Pluto guys. They DO check the smb.conf.template file.
Which brings us back to the initial question: Please check if you can find the client lanman auth setting in your smb.conf.template file.
Thanks.
-
Hi
lanman is not in the 14.04 template file.
Cheers
-
Hi,
Checked the 12.04 July 19 29194 load and lanman is in that template.
Cheers.