LinuxMCE Forums

General => Users => Topic started by: steven.herr on April 07, 2013, 03:57:58 am

Title: Onscreen Orbiter Volume Controls
Post by: steven.herr on April 07, 2013, 03:57:58 am
Hello,

I have installed LinuxMCE 1004 and managed to get a media director up and running, connected my Marantz SR receiver that uses IR codes to a USB UIRT, and created a new template in the AV wizard to control the receiver.  The "test code" buttons work to increase and decrease the volume.  I have UI1 as the Onscreen Orbiter of the media director.  I can play music.  When I use my mouse to open the "remote" of the Onscreen Orbiter I can pause and play the audio file.  I cannot get the volume controls or mute to work using my mouse by clicking on the volume up or volume down of the "remote".  I have rebooted the entire system and it still doesn't work.

Am I expecting something that LinuxMCE cannot do or is there a mistake in my configuration somewhere?

Regards,

Steve
Title: Re: Onscreen Orbiter Volume Controls
Post by: tschak909 on April 08, 2013, 05:48:35 am
It is important, while setting up your AV gear, to make sure the pipes are properly configured.

This can be done in one of two ways:

(1) use the setup wizard to specify your receiver, and how it's connected.
(2) use the web admin, go to Wizard > Media Directors, and make sure that the audio and video pipes are properly going to your TV and amplifier, respectively.

-Thom