LinuxMCE Forums
General => Installation issues => Topic started by: hari on March 17, 2012, 08:28:35 pm
-
does not look like a z-wave specific issue as the lights are there on the z-wave side...
-
please redo these steps and watch the dce router logs when reloading the router. See if there are "Delete Device" messages from the Z-Wave device to the General Info Plugin
-
This does not seem right
why not? that is just the status reporting
...and I am also not sure about this: ???
08 03/18/12 23:21:03.638 Received Message from 271 (ZWave / Home Theater) to 4 (General Info Plug-in / Home Theater), type 1 id 719 Command:Delete Device, retry none, parameters: <0x4f937b70>
08 03/18/12 23:21:03.677 Received Message from 271 (ZWave / Home Theater) to 4 (General Info Plug-in / Home Theater), type 1 id 719 Command:Delete Device, retry none, parameters: <0x4f937b70>
08 03/18/12 23:21:03.679 Received Message from 271 (ZWave / Home Theater) to 4 (General Info Plug-in / Home Theater), type 1 id 719 Command:Delete Device, retry none, parameters: <0x4f937b70>
08 03/18/12 23:21:03.680 Received Message from 271 (ZWave / Home Theater) to 4 (General Info Plug-in / Home Theater), type 1 id 719 Command:Delete Device, retry none, parameters: <0x4f937b70>
08 03/18/12 23:21:03.682 Received Message from 271 (ZWave / Home Theater) to 4 (General Info Plug-in / Home Theater), type 1 id 719 Command:Delete Device, retry none, parameters: <0x4f937b70>
08 03/18/12 23:21:03.686 Received Message from 271 (ZWave / Home Theater) to 4 (General Info Plug-in / Home Theater), type 1 id 719 Command:Delete Device, retry none, parameters: <0x4f937b70>
08 03/18/12 23:21:03.689 Received Message from 271 (ZWave / Home Theater) to 4 (General Info Plug-in / Home Theater), type 1 id 719 Command:Delete Device,
And mind you, this is with the Tricklestar USB stick, since I wanted to see if that would work better. Guess not. :(
ok. so the z-wave device is sending delete commands. I'd not yet blame the tricklestar, it was working fine here all the time.
We need to find out why the z-wave device believes it shall delete these devices. Could you please compare the nodelist in the debug output from before and after the reload?
-
You mean the nodelist from the "report" command, in the zwave device log?
no, i mean the nodelist that gets printed in the z-wave device log when you enable log level 36
-
i need the logs before and after the "vanish" event
-
maybe something stored in the eeprom of the stick was bad.. a rebuild would have overwritten the old, maybe buggy network config..