LinuxMCE Forums

General => Users => Topic started by: evilecho on December 23, 2011, 01:51:34 am

Title: Dianemo: NAS not being detected?
Post by: evilecho on December 23, 2011, 01:51:34 am
Hello,
  My NAS share is not being detected.... I ran: /usr/pluto/bin/MessageSend dcerouter 0 -1001 2 65 52 3 53 2 5 "X" 28 "Y" with the proper data... then I ran  "/usr/pluto/bin/MessageSend dcerouter 0 -1001 2 65 52 3 53 2 49 1837", then I ran "/usr/pluto/bin/MessageSend dcerouter <device id> -1001 2 65 52 3 53 2 49 1768" The system found my NAS and it found the share, but it didnt really detect anything.... after double checking ... it just now detected the file system and free disk space, but there have been no media files detected. I'm at a loss. Thanks.

_nate
Title: Re: Dianemo: NAS not being detected?
Post by: tschak909 on December 23, 2011, 05:41:34 am
what is the IP address of the NAS? Do you have your network configured to LinuxMCE's requirements?

-Thom
Title: Re: Dianemo: NAS not being detected?
Post by: klovell on December 23, 2011, 06:17:58 pm
Hello,
  My NAS share is not being detected.... I ran: /usr/pluto/bin/MessageSend dcerouter 0 -1001 2 65 52 3 53 2 5 "X" 28 "Y" with the proper data... then I ran  "/usr/pluto/bin/MessageSend dcerouter 0 -1001 2 65 52 3 53 2 49 1837", then I ran "/usr/pluto/bin/MessageSend dcerouter <device id> -1001 2 65 52 3 53 2 49 1768" The system found my NAS and it found the share, but it didnt really detect anything.... after double checking ... it just now detected the file system and free disk space, but there have been no media files detected. I'm at a loss. Thanks.

_nate

Try these instructions instead. http://wiki.linuxmce.org/index.php/Dianemo_S10.10#Detecting_Shares_when_adding_a_NAS (http://wiki.linuxmce.org/index.php/Dianemo_S10.10#Detecting_Shares_when_adding_a_NAS).  I would delete the device from the system and recrete it using these instructions. 

Good luck...
Title: Re: Dianemo: NAS not being detected?
Post by: evilecho on December 26, 2011, 02:13:08 am
Thanks again,
   Thom, my NAS's IP is 80.31 and works flawlessly with LMCE 1004. Klovell, I looked at the wiki.... and /etc/pluto/media_config.conf does not exists. Still open to all suggestions.
Title: Re: Dianemo: NAS not being detected?
Post by: tschak909 on December 26, 2011, 03:31:42 am
If I remember correctly, Dianemo's pnp plugin was castrated...