LinuxMCE Forums

General => Users => Topic started by: tryholymdba on August 13, 2011, 02:59:55 am

Title: How to send commands to ZWave decive
Post by: tryholymdba on August 13, 2011, 02:59:55 am
Well, i have tried to send commands to device model AN158-2 of Everspring. I try it with basic command (on/off) and i get  not i any response. I use set config param... What´s my error? thankyou of before hand. Greetings
Title: Re: How to send commands to ZWave decive
Post by: sambuca on August 13, 2011, 08:46:53 am
You have to send the commands to the zwave controller device, and specify the node ID of the AN158-2.

regards,
sambuca