Author Topic: Remove Camera  (Read 1840 times)

archived

  • Hello, I'm new here
  • Posts: 0
    • View Profile
Remove Camera
« on: September 08, 2006, 07:12:05 pm »
I installed a logitech quickcam on a MD to see if they work as the documentation claims and alas it did not. Now I cannot remove the camera entry on any of the orbiters , even though I have removed it from the admin webpage and regenerated and rebooted and reloaded  still it remains.
Any one have any ideas ?

Regards
Dean

archived

  • Hello, I'm new here
  • Posts: 0
    • View Profile
Remove Camera
« Reply #1 on: September 11, 2006, 10:00:59 am »
Be sure that you did full regeneration not just a quick.

archived

  • Hello, I'm new here
  • Posts: 0
    • View Profile
Remove Camera
« Reply #2 on: September 11, 2006, 10:19:47 am »
Thanks for the reply

I have done this more than once , to no avail.

I have since tried to connect the logitech webcam to my core , are you aware of any extra actions i need to take to get it to work. In the admin website under device status the camera  status is now run_config. What does this mean.

Regards
Dean

archived

  • Hello, I'm new here
  • Posts: 0
    • View Profile
Remove Camera
« Reply #3 on: September 11, 2006, 10:45:00 am »
I have a webcam in my installation. I followed by this newbielink:http://plutohome.com/wiki/index.php/Monitor_surveillance_cameras [nonactive] to setup it. Also, remember to install and load appropriate driver for your webcam. YOu can use a command dmesg to check if everything fine with your webcam.