LinuxMCE is a great solution for automation and integrating devices. I started this project a while ago, I found LinuxMCE while searching for a automation solution, but never got to finish it due to frustration. So I'm going to give it another try, with the help from the community. Also my goal is that this will help others, I'm sure that there are other beginners that are on a budget having similar issues like I am.
After installing LinuxMCE the on board audio doesn't work, also a capture card / TV tuner does not work. Also I have a X10 USB Wireless Transceiver CM19A that I can't get to work. How exactly do you install drivers in Linux and where do you get them from to enable these devices to work?
Then after the drivers are installed, if there is no template how do you get them to work? Especially the X10 USB Wireless Transceiver CM19A. My goal is to use the existing hardware that I have because it is convenient and also this project is on a low budget. I have experience in IT, but just not a lot of experience with installing drivers in Linux.
Thank you, all help in finally making this project successful is highly appreciated!